Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All. This summer we installed a MX100 firewall. At the time we only had the enterprise license and not the Advanced license. We had an old Barracuda 310 webfilter in place. Well we recently upgraded to a spectrum 200Mps/20Mps pipe and if ...
Hello All. We have a stub network setup with routing rules using LAN ports on the Meraki. One side is MX100 and the other is MX84. The traffic is routing well using this method. This stub network is dedicated to the connection between the loca...
Hello. We have a MX100 on one end and a MX 84 at another location. At the present time these 2 sites are NOT configured for a site to site VPN. However, we DO want to create a site to site connection but NOT over the primary WAN connection (not ye...
Thank you for the fast response I know I have not done any traffic shaping on the unit at all. I am glad to see you are getting great speeds so it is possible. I will check into the traffic shaping settings to see what can be tweaked. But nothing wa...
Thank you for the response. I did see the section to add traffic shaping rules. However, it seems like those only apply to the WAN uplink ports. It is unclear if that is the case or not. If the rules were not confined to the WAN ports this seems ...
Hello PhillipDAth.. The connection via a stub network on one of the Lan interfaces works great. Just static routes and good to go. However there is now another concern. We are checking into this but we are concerned that the data traversing wireless ...
