Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a customer that wants to set up a VPN tunnel with me with a Public IP address and a Public address for the host. I am completely at a loss as to how to accomplish this. The customer states that it against his company policy to have a remote ho...
Hello all I am having a hell of a time with a NAT rule I am trying to set up for a webserver I want to place into my DMZ. I have created a NAT rule and added the appropriate access rules but I am still unable to hit my webserver from the internet.I d...
I have installed a new SSL certificate on our ASA 5500. I removed the old one, installed the new one. And associated the trustpoints with the interface we use for Web Connect and AnyConnect connections.They are still seeing the old expired certificat...
Hello all. I have a ASA 5510 Firewall with the IPS Module installed. For reasons I am not aware of I am unable to access the IPS Module from the ASDM software. I have reset the password to defaults but am still unable to get access to the IPS. I get ...
Im not sure what he is asking for either. I do not want to NAT the RDP port to a public address. Is there a way that I can setup a site-to-site VPN tunnel on a specific peer address and then allow RDP connections on the same peer IP address but ONLY ...
Ok so I ran a packet capture and I cannot see any inbound traffic when I try and navigate to one of my public IP Addresses. I have a /29 network supplied by my ISP. I have my outside interface configured for (sanitized for security please let me know...
Here is the results from show run natnat (inside,outside) source static ACME_TERMINAL_SERVERS testCOX_Source_NAT destination static DM_INLINE_NETWORK_3 DM_INLINE_NETWORK_2nat (outside,dmz) source static any any destination static interface ACME-TMG1 ...
Weird now when I run the packet-trace command using the public IP address instead of the internal as Narayana suggested then it shows that it is working. However I am still unable to hit that IP Address.packet-tracer input outside tcp 192.168.0.1 102...
There must have been something wonky with the certificate install. I removed and then reinstalled it and it is running fine now. Although I have a lot of old trustpoints that are still shown as in use
