Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have two ASA 5510s in separate locations, connected across the internet.We have a site-to-site VPN between each of the ASAs that enables a SAN device at each end to replicate data to the other.The replication, when running, will consume all ava...
We are about to deploy a Microsoft Hyper-V High Availability cluster and I want to understand how my thinking on segregating the servers in the DMZ aligns with best practice.Each server in the Hyper-V cluster follows best practice and has a dedicated...
We have the following equipment, with a number of VLANs running on top:ASA 5510|DellPowerConnect 6224 (acting as a layer 3 device to route traffic between vlans and act as switch for servers etc.)|Catalyst 2960 (acting as layer 2 switch for desktops ...
We have configured a VLAN trunk between a Catalyst 2960 and Dell PowerConnect 6224. This works fine, and we can route between VLANs etc.The PowerConnect 6224 is providing L3 routing functionality, and the default gateway for the subnet - e.g. 192.16...
Hi,I don't think there was actually anything wrong with the config we made. I'm now able to see that stats to confirm that the policy is working... I just grabbed these from our device.Service-policy: Outside-Internet-policy Class-map: HQ-VPN-Qo...
Hi Jerry,Thank you for your reply. Your assumption was correct. I now understand what that particular command does now - and that the purpose of the interface on the VLAN is to be able to manage the switch on the VLAN, rather than act as the router...
Hi,I'm not sure I have an answer, however, we're currently in the planning stages of a similar project ourselves, so I thought I'd share our thinking...We're looking to deploy two Dell EQL arrays at two separate locations, with traffic going across t...
