Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just a general question to anyone out there that is using the Image Scanning Technology:What Verdict Ranges and Analysis Sensitivity are people using?We have set our to the following:Sensitivity = 65Clean = 0 - 69Suspect ...
Hello Everyone.I am after some advice, we are currently implementing the DLP Policy engine for all of our Outbound messages, and have had very good success with some of the policies, but there there is one that is not producing the results that we wo...
AndreasThanks for that, I was hoping this ewas the case. However I am now confussed.When we setup the DLP Policies originally, we want to ensure that emails that were being sent securly were excluded from any DLP scanning. To that end we setup a co...
Thanks for that I will do some more testing.On another note, we have configured the Contact Policy to only action on Critical Severities, all the other severities it does nothing with.I just want to run thgouh a scenario, if I were to have the Contac...
