About jlouis1920

jlouis1920 · 03-17-2009

Hi, I'm trying to successfully route traffic between two of my systems. I have 2 network both are using the ASA5520 (I've attach a diagram). I want network_A to communicate with Network_B. I've use a router in between (2811) and set an IP from networ...

jlouis1920 · 02-26-2008

I've been getting disconnected from My collo, and wondering if this error is the problem, "*Feb 26 17:00:16.083: %GT96K_FE-5-LATECOLL: Late Collision on int FastEthernet0/0" I know a collision can't be that bad, but can too many of them bring down m...

jlouis1920 · 03-17-2009

What I want to do is to transfer file from one network to the other. The additional routes were added on the ASAs like you have stated. But not on the Host OS. Once I applied the route to the host from both network respectively it works. My previous ...

jlouis1920 · 03-17-2009

1)Yes, the router is in between both ASAs. The router bounds both networks together. It is connected to my 3750s2)My ASA is in routed mode3)Yes,4)I've attached the configurations of the 3 devices

jlouis1920 · 02-26-2008

Thanks A lot Rick I will check with my neigbhor configuration before I apply this setting. Thanks Once again

Member Since	‎11-14-2007 10:56 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	5

User Statistics

User Activity

Routing Between ASA and 2811

1841 Collisions Error

Re: Routing Between ASA and 2811

Re: Routing Between ASA and 2811

Re: 1841 Collisions Error