Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If you are using VTP to propagate your VLANs to other switches then I'd suggest using the VTP Pruning feature. It will prevent unnecessary VLAN traffic (broadcasts/multicasts) from being sent to switches that don't require it. If you are not using ...
The 6500 series switches themselves do not support the disabling of IP routing. This command is usually used on low-end routers. Here is some Cisco documentation supporting it:http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note0...
The CDA model (Cisco's 3 Layer Hiearchical model) is typically used in a medium to large network - although, it can also be used in a small network, it just might not be financially feasible depending on the company's budget. The 3 layer architecture...
Hello,I don't know if this will work for sure but it looks like you will have to connect your cable modem into your ethernet port and configure the ethernet port to receive a DHCP from your cable provider like this:router(config-if)#ip address dhcpTh...
