Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey guys,I'm trying to redirect show commands output to a file, but I cant get it workingEverytime I use a command, like show tech support | redirect I get the message that the operation isnt supported in this file system, and after looking around in...
Hello readers!We have a Cisco 2821 with the IPS NME module in it wich is causing problems for our VPN..We have two gateways: x.x.6.1 (the router) and x.x.6.21 (software gateway)When we establish a VPN connection over x.x.6.21 everything goes fine.But...
gateway#show tech-support | redirect scp://username @ server% Redirect operation is not supported in this file system% Incomplete command before pipe.(Ignore those mailicons, no clue how to remove them)The command I use and the message I get
Thank you for your reply, Mike.I didnt give the full name of the module, its the NME-IPS-K9.I also did as you asked; turn on all policies and pass through the information I'll see. When I turned on all policies and tried to make a vpn connection the ...
Update:I've tried 2 new things:- Turned on all signatures and try to establish a VPN connection, no events logged that blocks the VPN- Turned off all signatures and try to establish a VPN connection, didnt work eitherSo there isnt a signature (I thin...
Frederico,Totally forgot to mention that when I posted this. I've turned the IPS off to see if the VPN works and it did. So that also confirms that all the traffic is going through the IPS.Marco
