Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I am updating an existing static route on our MX250 (Firmware MX 18.211) from a /24 to a /23 subnet as it is becoming full on a daily basis. I did the same on a different MX250 a few months ago with no issues.When trying to save I get the unh...
Hi All,I have been on with Meraki support and have resolved the issue now.I had to delete all the Flow Preferences then was able to make the change, then recreate all the flow preferences. Luckly we only had 6 and they were only Any to Any on certia...
Hi All,As part of a different change i have just tired to change part of a DHCP configuraiton at a different site and remove a "allowed VLAN" from a phycial port. Both changes are getting exactly the same error on different MX's.So this leads me to ...
Hi Kevin,I have just tried to setup a new static route to 10.19.163.0/24 which would be included if i extend the 10.19.162.0/24 to be a /23 but get the same error.I have also tried to setup a route to 10.19.240.0/24 which isn't in use anywhere on our...
Morning Philip,Here is a screenshot of the route i am updating, it has been in place for a few years and I am just changing the /24 to a /23.There are also no NAT's to port forwarding to this subnet.
