Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,we have a printer (2.4GHz required) that can't connect to MR42. no firewall rules. below is the summary of settings. on the printer forum, people uncheck uncheck 20/40MHz Coexistence and it works out. Per Meraki support, there is no 20/40 spect...
Disabled 802.11w and the printer shows connection successfully but when testing it. it says “failed to connect to the router".. now it shows IP and MAC. Should i add them to the router setting? if so, where it at?...
Network wide > event log > for access points no logs for the specific device And Wireless > health > select ssid for printer shows blankSsid settings: we don't have 802.11r/w separated options, only 802.11w is available.
