I'm looking to gain some insight on how to resolve a problem I have. Summed up, my network looks like this: We have two sides to the company, one side we will call office, and the other operations. On the Office side we use Vlan 10. We connect the of...
Hello,
I'm hoping someone could help me understand a couple of port configurations.
My WAN connection comes from my ISP into a Cisco 2800 Router (ISP managed) and from there it goes into my 3750 stack.
Router to 3750 stack config:
interface Gigab...
I believe I need to use a static route on one of my switches to fix an issue I'm having.
Here is the situation..
For simplicity, we will say I only have 2 switches and one router.
I have a 2960 switch on either side of my cisco router.
One 2960 is...
I've got 3 access points that, topologically, are in a triangle.
AP 1 connects to AP 2 and that connects to AP 3.
AP2
AP3
AP1
I'd like to change it so that AP 1 connects to AP 3 and not AP 2.
This is the, what I believe to be, relevant...
I currently have one branch of my network connected via copper lines, we are in the process of putting fiber to these switches, and I'd like to get the fiber up and tested while the copper is in place.
The connection I have now is from a 3750 to a 2...
Doh, I didn't see this message. I noticed my vlan 1 was working correctly just the vlan 10 wasn't. I've never worked with ACLs or these wildcards before.
I got it!! I had the wrong inverse subnet for my 192.168.208.0 network. Should have been deny ip 192.168.16.0 0.0.0.255 192.168.208.0 0.0.3.255 instead of 0.0.0.3. Thanks SOO much Jon, couldn't have even began this without you!
I could have sworn the internet worked before I did any of the ACL stuff, but I must be mistaken. I had to setup the route on my sonicwall for the vlan 16 to hit my core switch. I got that working. So internet is working, and all of my permits are wo...
That's very close to what I was doing. I was able to get the access to my specified IPs 192.168.209.24, 210.1, and 10.10.1.12 to work. I had the access-group 100 set to out at first, after I changed it, that took care of the deny. The issue I am hav...
So I've created vlan 16 as my new vlan for this single node. I gave vlan interface an ip address of 192.168.16.1, set the Node, my test machine in this case to 192.168.16.5 and configured it's interface to switchport access vlan 16. I'll need my nod...
