I see a default "deny all" inbound Layer3 rule on our MX. I'm going to assume that Deny All inbound layer3 rule has no effect if you create a NAT Forwarding rule. Is that correct? Just wanted to verify before I start creating Forwarding rules.ThanksS...

CommunityIf I setup a new Group Policy and select "Custom network firewall & Shaping Rules", are these custom rules merged with the existing "Global" Layer3 rules? or does it ignore those Global rules?I know for the content filtering section you can ...

We are creating a site-to-site VPN tunnel to a third party (MX 250 on our side, Palo 850 on the third party side). Since all of the layer3 FW rules are outbound only including VPN FW rules on the MX, how do I stop IP's on the remote third party side ...

Here is the scenario:We will have a setup of switches in a remote data center that we do not control (customer site, controlled by internal I/T). The customer wants a layer2 circuit between our DC and theirs. On the trunk port in our DC (Meraki MS) a...

I am looking at a solution for the following scenario:Customer has a private Metro-Ethernet connection between HQ and DC. Customer also has MX's in both locations, Customer has 2 ISP's at both locations (HQ and DC), both WAN ports at each location ar...