I have a T3 frame circuit which has about 20 subinterfaces defined along with DLCIs. Eache circuit connects to a different location. On of my locations is running into a situation where the keepalives are getting delayed (possibly building in the q...

I have 2 4006 switches, and each has a Supervisor III module installed. The appropriate SNMP community strings are set along with logging parameters. I have found that Cisco Works cannot manage the Supervisor III module and Campus Manager cannot ma...

I have a 4006 switch with a supervisor III engine. I want to use a sniffer which runs on a server to capture all traffic from a specific port. Since the sup III no longer uses the span or port-monitor command, how do I do this? I tried the "monito...

I have a 3640 with 2 hssi interfaces, connected to 2 DS3 circuits. I am load-balancing the traffic simply through 2 default static routes -ex:ip route 0.0.0.0 0.0.0.0 <isp's router>ip route 0.0.0.0 0.0.0.0 <isp's router>I also have the statement "do...

I have a 7507 router connected via a 802.1q trunk to a 4006 switch. When I launch Cisco Works 2000 (running on NT) and go into Campus Manager, then to User Tracking or Topology Services, I have immediate HSRP flapping on my 7507. Apparently, the co...