Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a client (w11 laptop running AnyConnect 5.1.4.74) terminating at an MX105 running MX 18.211.2. The client works as expected except for an SQL application that uses a remote server behind the MX105.Looking at the pcap, the client conver...
Ok, finally figured it out. The client VPN settings had "Dynamic Client Routing" setup. Somehow that was breaking it. Once disabled the client's SQL application worked as expected.It just goes to show you, challenge your assumptions!Thanks for eve...
Hi Phil, yes MTU did occur to me as well. I checked the eth2 sub int, used by the vpn client, the MTU is 1255 and ping -df implies I could go higher.@mloraditch - I did a capture on the MX internal interface. The conversation is normal, so the MX a...
Thanks M, yes both AMP and IPS are disabled, we haven't ever turned them on.I haven't ran a capture on the MX yet. My captures were run on the server and the client. I will since support will likely want that. I've already opened a ticket though.T...
