Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there,I am seeing odd failover behavior or really no failover at all happening. I have a MX68 with WAN1 working fine. I have a MG52 and connected it to WAN2. The device shows up, connected, and in a Ready state. Both green LED. When I pull...
Hello All,I am fairly new to Meraki. I'm tasked with getting a 3rd party NMS hosted in the cloud to SNMP poll devices in my organization. I have read several articles about enabling SNMP v2-3 at the Organization settings level and you can enter in ...
Hello there, I recently spun up a Meraki MX68 with the AP9164i's at several sites. Chromebook used to print fine to a local Zerox printer (wifi) on the same wireless network through the old infrastructure. We put in the Meraki and now the print job...
Hello,I opened a case a few days ago. They suggest a reboot of the MX. Well tonight I am upgrading the firmware and the reboot will take place as well. I will be testing this again tomorrow hoping for better results.
WAN2 shows a public IP from the sim provider. It is in a Ready state. From the Tools section on the MX, ping to 8.8.8.8 works fine selecting Internet2. Trace route dies as does MTR selecting Internet2. From the Tools section on the MG, the DNS Lo...
Basic Internet testing through the MG52 was tried on a laptop several days before we actually connected it to the MX today. It was just the MG52 and laptop and we had no issues getting to the Internet.
Hello all, I appreciate the responses. Issue seems to be solved! Legacy network was Aruba Instant On with no edge router. There was a setting in the Zerox printer for 'Postscript' we had to mess around with to make the Chromebooks print. Oddly we...
