Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Similar observation on our pilot device. Side note, we DID enable a Cisco XDR integration though immediately post upgrade. We upgraded on the 7th at 5:00pm. MX67C utilization screenshot. 18.211.5.1 to 19.1.8
We've been running 18.211.x for a while without issue. Have you tried upgrading? 8x Mx67c using cellular failover w/o issue. Users don't even notice internet outages now.
We were sold Cisco XDR on the promised integration with Meraki, requiring 19.1.7 FW or later. They failed to mention it required BETA firmware of Meraki. Fairly infuriating to be honest. we are on latest 18 release currently and our cellular is worki...
"Due to an MX 19.1 regression, traffic will fail to route over AutoVPN when the only active uplink is a cellular connection. (MX-35703)"Any update on this? Effectively makes the built-in cell failover of MX67/68's worthless.
Tested this yesterday. It was as feared. If WAN 1 or 2 are not connected, and in 'active' status, cellular will not autoVPN. This update effectively makes cellular purposeless. This FW version is required in order to integrate with CiscoXDR, part of ...
