Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Is there a way to load a new .bin file into the flash of a N7K-SUP1 without TFTP or other network file transfer protocols? If so, where can I find this documentation?
Hi Mark,
Ok. So, to recap:
I wiped the supervisor. When it boots, it goes directly to loader>. I can either run the generic commands from there or I can boot to my usb drive containing the kickstart file. From, there, I can set the ip address, gate...
Ok. I cleared the NVRAM and ran init system. I'm currently booted into the USB stick containing the .bin kickstart file. How do I copy this file into the bootflash? It seems if I'm in switch(boot)#, it doesn't see the USB. But if I boot into LOADER i...
