Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Thats all good and well but who as access to every single AP model ever made by every manufacturer, as long as your meeting the customer requirements an you use the access point to determine your cell edges & attenuation measurements you can then mod...
have you set the relevant country code on the AP, once this is set then AP should show 5 & 6GHz as working, also dont forget the 6GHz to a PSC channel.
Why not survey with it, it provides 6GHz capabilities and if you know how to survey correctly it's not about the AP, its about attentuation, airtime utilisation, capacity & SINR. the AP is just to to prove you can get signal into the desired areas fo...
Site survey mode on the CW916x models from a catalyst perspective you just have to ensure you have the correct image on the AP must be above 17.3 and it is a easy conversion to enable the AP to work in site survey mode. see below lin.https://www.jiri...
Just as i thought but i couldn't find that info when looking at the data sheet for the access point, didn't think to check the antenna documentation though. don't want to be ordering incorrect antennaThanks
