Hi all,I have 6504e with 2 Etherchannels (2x1Gbps links in each), active and standby, BGP over each towards ISP.Need to make etherchannel up ONLY when both members are up, to make etherchannel always have a capacity of 2Gbps.Any idea?
I am in a doubt if the 3560-12-PC-S supports OSPF. Datasheet says we need IP Services image.But 3560-12PC doesn’t have the option with IP Services.Then I havigate to http://www.cisco.com/en/US/products/hw/switches/ps5528/prod_models_comparison.html a...
Dear all,I am in front of a choice what to select to deploy 10Ge in my datacenter to get four 6504e and two 3750x units connected to each other.All devices are located in 3-7 meters away from each other.The choice is whether to go for a multimode fib...
Hi all.Making a total re-design of existing network at the company i work for.I use a standard three-layer structure (core-distribution-access) to get a normal looking and manageable network.I came up with 7 blocks connected to a redundant core, runn...
I have two switches and they both have the same thing.I have a layer3 uplink:interface GigabitEthernet0/1 description to core1 gi3/1 no switchport dampening ip address x.93.153.102 255.255.255.252 ip ospf cost 1 load-interval 30then an interface wher...
Thanks for reply.Different OSPF process will not make sense since routes still will mix in core...I thought of VRFs as well, it might be the most good way to solve it.The only thing is a configuration and troubleshooting complexity... VRF traffic isn...
Your configuration is incorrect. Static NAT cannot point one address (10.10.10.1) to two addresses the same time. How do you expect router to translate 10.10.10.1? What string should it use if it has two??!Solution: You need to define either the prot...