Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am experiencing an oddball of an issue today. Our company utilizes several MR42 APs for wide coverage. All the installations up until this point have been a breeze. Installed a new one today and registered the license, claimed the AP, etc. Ev...
[UPDATE] -- FOUND THE SOLUTION!As someone mentioned previously, the issue was with the switch config, not the device config. Netgear has a really dated UI and obscured the issue a bit. I was able to find it after digging around the other night.As see...
Good suggestion, I tried this and both DHCP and Static are flagging DNS/VLAN errors. When I attempt the same thing with other APs, no problem. DHCP happily assigns an IP and clients can connect without any issues.
The switch is statically assigned and the port is open. Nothing should be blocking the port. All the other APs go into various switches and it basically is just plug and play. Nothing needs configured from that end. Here is the VLAN info from Meraki:...
