Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 9800-CL that is port forwarding CAPWAP ports (finally got this working in OEAP mode) with a 3802I. The site where the 9800-CL is located has 2 vlans (vlan 2 - 192.168.2.0/24 and a 99 - 192.168.99.0/24). Both vlan's have a dhcp server setup o...
I'm having a dreadful issue with vWLC version 17.12.3. The 3802i I have was and can be connect locally to the controller but I cannot get the AP to register over port 5246 or 5247. When I checked the AP locally it does have the public IP address of t...
Interesting. This was the article I followed and it referenced flexconnect and OEAP still https://www.cisco.com/c/dam/en/us/td/docs/wireless/controller/9800/17-3/deployment-guide/remote-workforce-solution-wireless.pdf
Thanks for that. Are there any guides on how to setup a remote access point in flexconnect without a corporate router/switch at the end users house? Either a full tunnel or split tunnel configuration when accessing corporate data on the corp ssid?
The personal SSID is working with a 10.0.0.0 network going through the home router but I just can't figure out the corp SSID side. No matter what I can't get it to pull a dhcp from the 192.168.99.0/24 network.. I can route and ping from the 192.168.9...
I thought it was always called WLC and vWLC for simplicity sake but for this thread I'm referring to the 9800-CL. I was able to stand up an older version of the 9800-CL (17.3.1) on another Edge Router with a different public IP address and was able t...
Interesting. I'm not totally sure if that is accurate or not but when I had the AP on the same subnet as the vWLC I had a 3rd icon on the AP when it was joined over Flexconnect with the OEAP profiles I configured. I was able to test OEAP connectivity...
