Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
good morning dear, I have an active VPN but I want my users not to use the office bandwidth to navigate but on the contrary, to use their own internet and in the VPN only use fileserver, erp and telephony. Is that possible?
I have 02 links (primary and secondary) automatically my VPN goes through the primary one but I want the VPN to go out through my second link every time I have a drop in the main internet, I have the autoVPN configuration activated.
Hello, I have the same problem, but it is recent, I have 02 schedules in which my users connect, those of the first schedule connected without problems but those of the second schedule, they cannot get an error message "the connection was lost becaus...
Thank you very much for the help, I was finally able to use my wan 2 with my vpn, the problem was that I was behind a nat, my provider disabled it and I was able to connect.
Hi PhilipDAth,I tried to configure what it indicates but even so my wan 2 does not raise the VPN, my users cannot connect to the VPN, I am going to ask my provider to remove the NAT from the router and for my FW to take the IP of the router.
