Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi we have a network setup like this:ISP setup:2 ISP uplinks for 2 Juniper firewalls.We have been given 4 public ips to use.There is a VRRP heartbeat configured between the Junipers.They are setup as active/passive. ie if the primary Juniper fails, S...
Yes, i think you're right Marvin. That also sounds like the most redundancy. Though i'm fairly certain it's going to cost more to purchase more switches than get our ISP to give us 2 active lines.
Thanks for the reply Marvin. That's super helpful.Ah so that confirms my suspicions. Does the breakout switch need to be a managed layer 3 switch for this to work? I did try using a dumb layer 2 switch but i think it started causing loops.
