Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Anyone familiar with transferring a WSA v7.7.0 config to a WSAv v8.0.5? If I'm reading the documentation correctly, its a direct upload yet it fails with errors in the config file.thanks,Chris
Hi all,I'm testing the S100V virtual WSA on unsupported hardware (Dell PE1950, 8Gb 667MHz RAM, 3 disk RAID5 10kRPM, Dual Intel Xeon E5320 1.8GHz Procs) and I'm finding response times on many pages to be very slow. We're using forwarding so I can swap...
It appears you are correct, Vance,I've enabled Adapting Scanning along with AVC and performance increases markedly. I searched the knowledge base for poor performance issues but this bug wasn't returned. You would think Cisco would make such defect l...
Vance,its been running without adaptive scanning. I've disabled App and visibility control and it definitely made a difference. Leaning towards the memory speed as the culprit.Chris
Thanks Jodi,was wondering whether the virtual appliance was ready for production environments. Your performance results would suggest so. Apparently my hardware isn't up to task. Looking at the performance charts via ESXi client, the hardware doesn'...
