Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi...I would like to capture the activities such failover... When it fails and how it failss...Would I use Cisco Secure Policy Manager or Cisco Secure Access Control Server.Would someone point to correct direction please...Thank u.R.
Hello everyone,I would like to use NAT 0 and port redirection on mypix 525; however, PDM does not support these functions. I also contacted TAC support Engineer; he told me that new version 1.1 PDM was available last month. I could not find the sof...
Thanks Abinjola,My bad … I forgot to rate the post. You already knew the scale is always 5! It is very helpful.I would not mind to have some downtime.So Could I upgrade two steps 7.0(1) and 7.2(3) right way.Let's say… I upgrade from 6.3(5) to 7.0...
Abinjola,This next week, I would like to upgrade my pix 525 from 6.3(5) to 7.2(3)and asdm-523.Do i have to upgrade to 7.0(1) first then 7.2(3) ?Could you please verify and my step by step procedure...1) power down pix22) upgrade pix1 (primary pix) ...
Martin,Do you have a chance to implent the logical interface (virtual interface) ?As you can see, 6.2(2) pix does not support virtual interface; however, 6.3(1) does. To answer your question, after you did the configuration, you must useclear xlate ...
I went through a bit on new feature of pix 6.3.1 (commands).It said that It supports logical interface;however, it does not support any example. Does it work similiar to router virtual interface ?Could explain me and show some example please....Than...
Hi Robert,I got global (dmz) 1 172.16.100.10 and nat(private) 1 0.0.0.0 0.0.0.0.I don't have global (global). What do you need that statment for ...?Could please you explain ... Thank u.Our Version is 6.0(1). I believe It has a bug, from time to ti...
