PDM 2.1.1 & Image 6.3.1

[ffiordaj]

Will PDM 2.1.1 work with the new PIX OS image 6.3.1 or must I install the 'beta' version of the new PDM?

Thanks,

Tony...

[gfullage · Accepted solution]

It'll work it just won't support all the new 6.3 features. PDM v3.0 will support all 6.3 features and should be available in May.

[syghafoor]

you will need to install the beta version of pdm.

thanks,

Syed

[rpel]

I went through a bit on new feature of pix 6.3.1 (commands).

It said that It supports logical interface;however, it does not support any example. Does it work similiar to router virtual interface ?

Could explain me and show some example please....

Thanks

R.

[btwnpipes]

I have intalled 6.3(1) okay, but PDM 2.1(1), won't work. The sh hard shows it's there but when I try to access it, it says I need a "new image", which is what I thought the 2.1(1) was (from 2.0(2). Is PDM 3.0 available in beta? Has anyone successfully installed PDM 2.1(1) on PIX 6.3(1)?

Thanks,

Mike

[yizhar]

HI.

I had the same results.

On a pix 501 I have upgraded from 6.2(2) to 6.3(1), and from PDM 2.0(2) to 2.1(1) - PDM did not work and poped up a message to install a newer version.

I have installed the beta version of PDM 3.0 and it works fine.

Yizhar

[asafayan]

I had the same experience as Yizhar described.