Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Community,I have a network setup using MS 350 for my core switch and MS 250 for access switch.my ISP connection is terminating on a cisco 2960 switch, from there the internet connection is connecting to a firewall device and then to my core swit...
What if the access switches are stacked to look like one and the traffic is spanned from all the switches in the stack to a single port on the switch stack.Can that be possible.
by this "you need to set this to an ip and gateway in the subnet of your upstream link." you mean i should use an ip address from the uplink to the firewall device?
Yeahthey both have IP addresses from the 172.16.15.0/24 network with 172.16.15.3 being the gateway.the firewall device can ping the gateway interface 172.16.15.3 on the MS 350.I even changed from static IP address to DHCP on vlan 15 to see what will ...
I don't think the firewall is blocking anything because there is a MS 250 switch connecting to the MS 350 core switch and the meraki box has access to the internet.There is connection THROUGH the box, but the box is not connecting to the internet.
