Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am new to this company and on the profiles is says New Basic Indoor ProfileApplied to 104 APs. Overrides applied to 104/104 of these APs. I have been searching and can't find a good explanation on where that is set and why.. I am still learning Mer...
I am still in the Meraki learning phase but have been doing networking for 20 years but seeing an issues I can't explainI just took over this environment so don't know the history but was brought in because they are having issuesFound a AP that had a...
Just wanted to post a follow up..Its acting up again and pointing to the cable..Even through it tested clean I am havign them replace the ends.It may work great for a week then drop which makes troubleshooting hard
Wanted to send an update. Yesterday I physically swapped the suspect with a working AP in the ceiling expecting to get a direction. The only thing I did was pull one AP down and move it. Cables ports everything else stayed the sameStrange part is AP-...
What makes it hard to troubleshoot is it up now and has been for 3 hours..They tested from end to end with a fluke tester..Tomorrow morning I am going to swap the ports on the switch.Depending on what happens I will swap the AP'sMeraki support also s...
Hoping somebody has seen this before..When it was down cable test said unknown but not ITS WORKING for some strange reason and cable test passes.I am seeing this in the logsPort 14 designated→disabledport: 14, old: 1Gfdx, new: down
