Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Raghav,
Translating multiple mapped IP to one real IP address is not possible in static NAT.
If the real IP address is running multiple services then you may use static PAT to translate one service of the real IP to each mapped IP.
But in s...
Hi Kenny,
The problem could be with authentication.
Please validate the username and password entered on ASA and modem.
If does not help please enable the following debugs and share the output :
debug pppoe event
debug pppoe error
debug pppoe...
Hi,You will not loose ssh connectivity to the device when you run the following commands :crypto key zeroize rsacrypto key generate rsa modulus 1024If you close the ssh session before running the second command, then you will loose connectivity over ...
Hi,If you are not seeing the traffic destined to Z.Z.Z.Z on the inside interface and if you confirmed the same using packet captures, then check the routing on internal devices to confirm if the packets destined to Z.Z.Z.Z are routed to the ASA or no...
Hi,If you are looking for SNMP OIDs to get 'show local-host' output from ASA, please try the following OIDs and check if you are getting the relevant outputs : 1.3.6.1.4.1.9.9.147.1.1.1.2.1.5. cfwBasicConnectionEventType 1.3.6.1.4.1.9.9.147.1...
