About HosamHasan

HosamHasan · 05-29-2019

I am facing issue with all clients in some branches Association and authentication failure, log as shown below :Associationtype='Association attempts' num='264' associated='true' radio='1' vap='0'Authenticationtype='802.1X auth fail' num_eap='6' firs...

HosamHasan · 04-26-2022

@Philip D'Ath Many thanks for your response, sorry for the delayed reply, that's definitely useful to customise the first page which is to enter the username and email address but I need to customise the next page which is to enter the sponsored pers...

HosamHasan · 04-13-2022

@Philip D'Ath Thanks for your contribution on this, Can't find any way to download the sponsored splash page to customize it, could you please elaborate on how to do that from the dashboardAs per Meraki documentation you need to create a specific do...

HosamHasan · 02-22-2022

Tip 1 - Don't waste your time on manual ways of working on Meraki DB for enterprise Go and learn API, Postman is a good start, then better to learn python Tip 2 - always read Meraki documentation before you do any change, especially when you work in ...

HosamHasan · 07-08-2019

As mentioned above check MTU some ISP use low MTU fragmentation size you can use packet capture from from the AP with failed connections , another thing happened recently microsoft push update for TLS from version 1 to 1.2 so make sure your radius ar...

HosamHasan · 06-11-2019

Solution found by change the TLS on the RADIUS server to work with TLS 1.2

Member Since	‎03-19-2019 02:07 PM
Date Last Visited	‎03-28-2026 01:17 AM
Posts	8
Total Helpful Votes Received	9

User Statistics

User Activity

Wireless Authentication Failure with Radius

Re: Sponsored Guest Access to provide specific email address for the sponsor

Re: Sponsored Guest Access to provide specific email address for the sponsor

Re: Community Challenge: Two Twosday Tips

Re: Cisco ISE radius WLAN authentication not successful with some locations.

Re: Wireless Authentication Failure with Radius