Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I'm trying to setup a zone based firewall. I can't seem to work out what is going wrong. I have added the class maps, policy map, extended acls, and have defined the zones and added the zones to the interfaces. Can anyone see why this wouldn't be ...
Hi I'm configuring BGP over a GRE tunnel? Do I have to have BGP across all routers say if the neighbour is a few hops away? I have configured multihop. I have static routes set up so I can ping to and from each router. It's a IBGP and EBGP peer set u...
Hi can someone help I'm setting up a gre tunnel as a little homework for home and i'm not getting any of the routing right. Can someoneexplain with my configuration where i am going wrong? I'm just trying to get the hang of it. I've been doing static...
Hi as far as I can remember I can ping from end to end. I've configured keepalives on the gre tunnel and it is in an up and up state. There is no ACL applied to tunnel and the tunnel source is the loopback interfaces on the routers. I'm using another...
The tunnel is in an up state and i can ping from end to end. I just had some crappy static route skills that i needed to work on. So how do I test that the tunnel works? Why would I have to configure keepalives on both ends? It's to prove that it is ...
hi thanks for all the replies. R2 is the second router connected. The tunnel end point is on R4 which I haven't listed here because all I really needed to know is what static routes to use in between both R1 and R2 to establish connectivity. R4 also ...
