Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI'm using a wlan controller with 1242ag converted to lwapp, i'm trying to enable 5.8 but when i change the from local to bridge the lwapp disapear from controler. Someone told me that the firmware does not support mesh !I'm folowing the 4402 wlan m...
HiI have never work before with Wirelles controller and LWAPP before, but I understand the theorical about this. Here is my scenario and doubt.Reading the documentation of Wlan controller i found how to create Wlans, ssids, secutity profiles and etc....
Yes and it doesnt apearEduardo By IPhoneEm 11/10/2011, às 09:36, gstefanick escreveu:Cisco Support CommunityRe: lwapp 1242ag doesnt show meshcreated by George Stefanick in Other Wireless - Mobility Subjects - View the full discussionI understand it ...
Yes it was registered when i change it to bridgeEduardo By IPhoneEm 11/10/2011, às 09:22, gstefanick escreveu:Cisco Support CommunityRe: lwapp 1242ag doesnt show meshcreated by George Stefanick in Other Wireless - Mobility Subjects - View the full d...
