Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Setting up a new IE3200 switch. I am using putty and secureCRT to configure. Both programs will not allow me to configure. I have verified Baud rate to be 9600 and also adjusted settings to v100 and set the flow rate to none. I flowed Cisco’s guide t...
If this is a switch issue, Cisco needs to address this. The boot screen reads just fine and so does all Cisco iOS outputs. It’s our inputs that extra characters are added and garbled up.
The switches are straight from the factory at Cisco. I'm doing initial setup. Its very frustrating because it makes me set an enable secret password and when I type a character it types 4 characters, and if I copy and past the password in, it just pa...
