Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello-We have an ASA 5510 that has been in production for some time now and all has been well. Traffic on it has been increasing over time, but nothing outrageous. Two days ago we began taking MAJOR input errors (every single one is an overrun) on ...
Quick note on a feature request that we would love to see... That is the ability to define traffic shaping policies on a subinterface. Currently this is only permitted on a physical interface.Thoughts?
Hello-We have a bit of an issue here. The UC560 supports the ATA 186, but that product has been end-of-sale'd. There is now an ATA 187, which I understand to be SIP only (no SCCP) and the jury seems to be out on whether the 187 is supported by the...
Hello-We had a rather strange thing happen tonight in our data center. We have a VMware environment, multipath with two HP P2000 SANs (each with two dual-port controllers) and two MDS 9124s. One port from each controller on each SAN is connected ...
Are there any plans to support Octo lines on the SPA525G2 (and perhaps other SPA500 series) phones? Is there a technical reason why we do not have this capability today?ThanksRick
Varun, others-First I wanted to extend my sincere gratitude for your help in getting to the bottom of this issue. Capturing the packet data, I was able to identify THREE servers which were inexplicably sending out occasional, but very large, broadca...
Just a quick follow up. As we continue to watch, we have seen two spikes above 25k pps, and one as high as 60k pps. Again, no corresponding traffic on the outside interface.This is all OUTBOUND from the inside interface.It is almost as if the traf...
Varun-I will take a look at the link. Also, check out the attached image! It seems that things chug along nicely and then, suddenly, there is a HUGE traffic spike on the "inside" interface. When I say huge, I mean we go from an average of less ...
Ok, so I ran the clear int and then did show int three times at one minute intervals. I followed that with a clear asp drop followed by show asp drop at three minute intervals. I finished with two more show int.The impact this issue is having on ou...
