Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody,I'm actually studying CCNP route/switch certification and I have a question with the topology below.
I try to understand the mechanism of the GLBP protocol. So I made a real lab with some gears.
The following problem is that R3 have 2 de...
It's a Cisco 2811.
With the IOS version below installed.
ithe Description:ASK9-AISK9 FEAT SET FACTORY UPG FOR BUNDLESRelease:15.1.4MRelease Date:25/Mar/2011File Name:c2800nm-advipservicesk9-mz.151-4.M.binMin Memory:DRAM 512 MB Flash 128 MBSize:62.7...
Hi,
Yes is taking the correct path for all of my computers (SW3 and R4).
But, how I can do if I want to do load-balancing between my two links towards R2 and R1 ?
I would to use both of them. It's possible ?I just would like to load balance the traff...
Hi reza,Thanks for your time
Please find below the results of the "sh run" and "sh ip route" commands on R3 before the modification.
And more below, the results after the modification with your proposition.I understand the metric of 100 for the sec...
Hi Bilal,Thank for your response R2 has already the route configured
ip route 3.3.3.0 255.255.255.0 172.16.2.2
And R1 have this one
ip route 3.3.3.0 255.255.255.0 172.16.1.2I changed the incorrect route in my scheme. But it's just an oversight. So...
