Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a C12008T-D. Latest firmware. Created VLANS. When I go to join and change Access VLAN ID to correct assignment and the same for General PVID the WEB GUI sticks and have to unplug and plug back in to regain access after I apply. Seems to be...
That’s the problem I can’t make it save hangs up after apply. It’s funny because it only hangs on the 2nd VLAN while the 1st was successful being trunked.
