Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I bought a Cisco Catalyst switch from a hamfest (amateur radio swap meet) and am trying to get it working. I am a retired software engineer and am just looking to get this working. I can connect to it through a serial conection and can run some ini...
Leo,That made some difference but ended up with the same results. I did the following:Started up the switch with the MODE button pressed until SYST light turned amber. Got the switch: promptResults :switch: set SWITCH_IGNORE_STARTUP_CFG=0Can't set ...
System would not allow that move. Booting...Interface GE 0 link down***ERROR: PHY link is downThe system has been interrupted prior to initializing somefilesystems and loading the operating system software.Console will be reset to 9600 baud rate, ne...
Here you go: Booting...Interface GE 0 link down***ERROR: PHY link is downThe system has been interrupted prior to initializing somefilesystems and loading the operating system software.Console will be reset to 9600 baud rate, need to change terminal...
I have purchased a third Cisco Catalyst 3650 switch and am getting the same response from each switch whether I start from server being factory reset or just waiting for the switch to complete it's boot procedure. When it gets to "Press RETURN to ge...
