Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About joelconary
Stats
Member since
10-03-2011
4
Posts
0
Helpful
0
Solutions
Created by
joelconary
in Unified Computing System Discussions
in Unified Computing System Discussions
10-24-2011
11:54 AM
10-24-2011
11:54 AM
Hi Andries, Sorry, I meant to update this but hadn't gotten around to it. Yes it was resolved, but unfortunately it required replacing the chassis. After opening a TAC request a field engineer came out and swapped a new chassis for us. Best of luck.
... View more
Created by
joelconary
in Unified Computing System Discussions
in Unified Computing System Discussions
10-10-2011
11:22 AM
10-10-2011
11:22 AM
Padramas, I've opened a TAC service request and attached the CIMC technical support data export. Thank you again for your assistance.
... View more
Created by
joelconary
in Unified Computing System Discussions
in Unified Computing System Discussions
10-05-2011
09:57 AM
10-05-2011
09:57 AM
Hi Padramas, I get the same behavior through SSH and the command line. I've attached a screenshot of the results (pardon the mistakes - I was dictating commands to a colleague). In addition to this step I've also completely powered down the system, removed the PSU's, reset the CMOS battery, and reflashed the CIMC firmware and BIOS. No change in results so far. Thanks for your continued time and help.
... View more
Created by
joelconary
in Unified Computing System Discussions
in Unified Computing System Discussions
10-03-2011
05:08 PM
10-03-2011
05:08 PM
Hi folks, I experienced a UPS failure which dropped one of my C210 M2's. It came back up fine, ESXi fired right up and it's successfully hosting several VM's so everything appears to be technically operational. However, in the CIMC my inventory screen is coming up blank. Nothing shows on the CPU, Memory, or Network Adapters tabs. Power Supplies and Storage appear to display correctly. PCI Adapters gives the following notice: "Error: Operation failed" in a pop-up window. Is there a way for me to force the CIMC to repopulate my inventory. Is the fact that it's blank an indication of damage? Thanks in advance for any help anyone can offer.
... View more
Labels:
Created by
joelconary
in Unified Computing System Discussions
10-24-2011
10-24-2011
Hi Andries,Sorry, I meant to update this but hadn't gotten around to it.
Yes it was resolved, but un...
Created by
joelconary
in Unified Computing System Discussions
10-10-2011
10-10-2011
Padramas,I've opened a TAC service request and attached the CIMC
technical support data export. Than...
Created by
joelconary
in Unified Computing System Discussions
10-05-2011
10-05-2011
Hi Padramas,I get the same behavior through SSH and the command line.
I've attached a screenshot of ...
Created by
joelconary
in Unified Computing System Discussions
10-03-2011
10-03-2011
Hi folks,I experienced a UPS failure which dropped one of my C210 M2's.
It came back up fine, ESXi f...
Public Statistics
| Date Registered | 10-03-2011 04:49 PM |
| Date Last Visited | 08-18-2017 03:55 AM |
| Total Messages Posted | 4 |
