Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Very recently, we had implemented Site-to-Site VPN tunnel between two Linksys RV042 4-port VPN routers. Everybody in our remote site is accessing and sharing the data through this tunnel and it is working fine.Now, we have another DSL connection (...
Hi,Very recently, we had up graded our Leased Line's B/W from Serial 2Mbps to FastEthernet 4Mbps. Router A is Cisco 3845 and Router B is Cisco 1841.We had changed the HWIC's cards also to HWIC-2FE on both ends as per our requirement.IOS also upgraded...
Hi,Very recently, we had implemented Site-to-Site VPN tunnel between two Linksys RV042 4-port VPN routers. Everybody in our remote site is accessing and sharing the data through this tunnel and it is working fine.Now, we have a plan to implement the ...
Hi,I have two parallel WAN links ( 2Mbps each ) between our offices. I observed frequent increments in output drops on serial interfaces in working hours. Need a solution for this.VC Gundapaneni
Hi ,I am unable to ping DMZ series IP from the VPN client. I got response and accessed all of my local lan IP's.What;s the problem?What ACL i have to give?VC Gundapaneni
Joseph,After describing the policy on both routers, i observed many output drops on both sides interfaces. They are frequently incrementing. What i have to do know? History of our WAN Link (2Mbps) is works between two serial interfaces and now it is...
Dear Joseph,Thank you very much for your frequent replies against my queries.Still we are getting the high latency after i add the policy described by you.Pinging 10.1.1.20 with 32 bytes of data:Reply from 10.1.1.20: bytes=32 time=147ms TTL=124Reply ...
I added the same policy on both end routers.Is it correct ? But, latency is reduced to 42ms. But, one thing i need is "how to get the best throughput from this 4Mbps WAN? What config. i required for this? Please do the needful.