Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How do I set up a Static default route for a particular vlan on a RV34x series router?
I am trying to send all traffic from a particular subnet over the VPN. As of now only traffic destined for the VPN network will go over the VPN but I want ALL traf...
Hello Community,I've got an MX67. WAN2 is set up as a fail over WAN but my issue is that it's actually an LTE router. I do not want all traffic to flow over that WAN when WAN1 dies. I only want mission critical traffic to run over that WAN.How can I ...
I can save settings in any other merki screen on the dashboard but when I try to save a new group policy I get this error. I have full admin access in the Organization. What gives?I've never ran into this error before. And there's nothing wrong with ...
Oh I see what you're saying. In order for VRRP to To kick in and make the secondary router primary, the primary router has to have a hardware failure where it can't answer the keep alive. Not just a WAN going down
So then how does VRRP work normally?If the whole point is to have a standby router that can jump in almost instantly to route traffic If the main router goes down, wouldn’t the limitation of needing to have identical WAN settings Keep this from worki...
