Can somebody explain why some rules have the amount of matches next to it when you do a show acl command on CISCO 3845 ASA and on some, for instance, the allow http traffic command shows none.here's an example; 2260 permit tcp host 10.220.*.* host 10...

I have configured HSRP with the following config;interface GigabitEthernet0/0 standby 1 ip x.x.x.x standby 1 priority 101 standby 1 preempt standby 1 track GigabitEthernet0/1 standby 1 track GigabitEthernet1/0 standby 1 track GigabitEthernet2/0!inter...

I have x2 3845s running IOS security and HSRP. I would like to run DHCP from these routers, but was wondering what happens in a failover situation?Can the DHCP leases be sync'd between these routers?

I have two 3845s running IOS security, configured with HSRP for redundancy.At the moment I am having to duplicate the ACL entries on both routers.Is there a way of having an ACL change made on one router sync'd(copied) to the other?