About gerrit.lehr

gerrit.lehr · 10-11-2011

Hi community,I am currently working with the Cisco support on this but since this won't progress for a couple of days I thought it can't hurt to ask around the community and share my situation.I have a UCS system with two FIs connected via one 1GB Up...

gerrit.lehr · 10-19-2011

The switch is running in Ethernet End Host mode.Thanks heaps for all the information, I will try configuring a portchannel between the devices.

gerrit.lehr · 10-16-2011

Hi Harold,I did try to get this working but had no luck so far. Neither disabling STP on the uplink ports nor enabling and configuring it as edge ports worked. It still does a topology change as soon as more than one uplink is connected and screws u...

gerrit.lehr · 10-11-2011

Hi Harold,thanks a lot for the reply. This does indeed sound very similar to the issues my customer is seeing and I will check the STP config of the switch tomorrow and definately let you know about the result!Did you manage to solve the problems by ...

gerrit.lehr · 07-19-2011

Well, I ended up getting an additional set of MDS Switches since Cisco does not recommend using direct connected FC / FCoE on the 6100s with default zoning anymore due to default zoning apparently leading to major problems with failover and RSCT. So ...

gerrit.lehr · 05-27-2011

Hi Jeremy, is there any official statement on direct FCoE connection between UCS and VMX not being supported anymore?

Member Since	‎05-27-2011 01:12 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	6

User Statistics

User Activity

HSRP and Loop Problems with UCS

HSRP and Loop Problems with UCS

HSRP and Loop Problems with UCS

HSRP and Loop Problems with UCS

Re: Booting UCS from EMC VNX5300

Re: Booting UCS from EMC VNX5300