Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a need to completely automate configuration of my ACI fabric and as part of that we need to include Fabric policies and Access policies, however the documentation primarily just covers in-tenant configurations. Is it possible to configure fab...
It appears that the NGIPSv is not yet fully supported by the Firepower Device package. Check out this thread below:
https://supportforums.cisco.com/discussion/13165116/firepower-device-package-aci
Depending on your load, it might be needed to have both dedicated border leafs as well as service leafs. The difference between the two types of leafs is a follows:
Dedicated Border Leaf: dedicated to L3Out functionality to external L3 devices such...
You may need to ensure that you do not have LLDP enabled on the VIC of the APIC. Log into the CIMC web interface and under the system settings look at the VIC configuration. Make sure that Enable LLDP is not checked. If it is, uncheck it and reboo...
