Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I needed to purchase a block of 8 IP's for a few new servers and my ISP gave me a set of totally different IP's than what I currently have. How can I add these to my network and is it a pain to setup? The current public IP for my 5510 is 209.254.56.X...
I have an issue sending emails to only a few different sites. Most of my emails are sent/recieved with no problem but a few I see the response below on my ASA when I force a resend from the Queue on my Exchange email server. 4 Apr 11 2007 12:07:38 10...
I have 3 internal MS Server 2003 that need to be accessible from the the outside. The server IP's are 192.168.0.237 needs ports 21095-21096, 192.168.0.240 needs ports 21093-21094 and 192.168.0.242 needs ports 21097-21098. I need to allow all traffic ...
I have a Unix server on my internal network and when I VPN in to my office I can't connect to it. The Unix server has an IP address that's in the range of all my Windows 2003 servers but I can't ping it or connect to it. If I'm sitting in my office e...
I could really use some help getting this ASA 5510 configuration done. I?m by no means a firewall guru but since I?m the only network engineer at my company I?ve been asked to make the new Firewall/VPN work. I?m trying to setup the network to have a ...
I had the firewall all setup and I still couldn't get access to my new server but I knew the firewall was right. My ISP finally figured out that they were blocking my new range of IP's so once they fixed that everything started working. Thanks for th...
Yes the ISP is routing the new subnet to my PIX. This is all on the same connection so I'm only using a single interface on my PIX for the connection to the ISP's router. They did give me another gateway address for the new list of IP addresses and t...
These are additional IP's so I'm not replacing the 209's. So all I need to do is add a static route on the external interface with each new IP address and the new Gateway IP they gave me? Could you give me an example config? I should be able to figur...
