Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I've noticed that from time to time some of our flex connect AP's will join our less preferred 2504 anchor WLC instead of staying on the 5508 HA pair controllers. The 5508 HA (active/standby) pair are in the same mobility group as the 2504 to fac...
Hey, We have a pair of 5508 WLC's configured in HA (primary/standby). We have a single SSID that we're broadcasting across each floor of our head office. The AP's are in flexconnect mode so users pickup an IP address from the DHCP range for that buil...
Hi,We have a pair of 5508 WLC's in a HA configuration that is working well at the moment, however I have noticed that the management interface is configured as untagged. I would like to change this to tagged and change the attached switch to trunk fo...
I decided to create a separate VLAN for each wireless site rather than using the regular floor VLANs and we are now roaming fine between floors (as one would expect). After doing some more research into it there's really no way to ensure that a user ...
Hi,Thanks for your response. Yes it's a pretty small setup with about 50 AP's at present. All of them join the single 5508 HA pair, but because it's active standby it's a single controller that's highly available. As a work around I'm investigating p...
So if I can disable HA the management interface settings will no longer be greyed out and can be changed? I've been searching through the Cisco doco and haven't found how to disable redundancy. If you can point me in the right direction that would be...
Thanks for the reply.I don't mind making changes during a maintenance window, what I don't want to if it can be avoided is have to reconfigure things from scratch.The main reason I'd like to change it is that we'll be looking to add some access contr...
