Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am creating a vlan on a 4948 and I have assigned the GigabitEthernet ports 1-6 to vlan 5.I used the no shutdown command for each interface, but yet it still says GigabitEthernet 1/1 is down, lilne protocol is down. I understand the line protocol...
Hi,I want to install another WIC and another T1 line into our 2811 routers so that we can have two T1 lines between our offices. We currently have one T1 line, but we have an application that consumes the bandwidth, so we would like to install a seco...
I think I blocked everyone on the network from accessing the Internet via port 80. I was using the Cisco Network Assistant and I thought I was blocking port 80 only for fa0/8. However, I think I ended up blocking port 80 on all ports instead! Now I a...
I have an SNMP community string that is incorrect on a Cisco 2811 router. I can't seem to change the snmp-community name. What are the commands to change the name?
I recently read in a CCNA book that you can only configure VLAN's one port at a time. There is no command available with older switches, like a 1900 series, that lets you assign more than one port to a VLAN at a time. I am a little confused by this....
Oops! My bad!As soon as I plugged in the cable, both went to UP.I thought that the interface was supposed to be up and the line protocol down in this case.
I got it. You need to put "" around the name of the access-map. I was not using "" before. So for example, you need to type:no vlan access-map "SecWiz"
We will be purchasing used/refurbished equipment because there is no way the management will approve two new switches that could run 8-10K. You said, "You can also have a voice Vlan and a data Vlan on the same port." Well, that is exactly what we wil...
