About John.Syd.Aus

John.Syd.Aus · 08-15-2014

I'm hoping someone can help. On two 5525X ASA's one is running 9.1(1) and the other 9.1(4). I'm a read only user with privilege level set to 5.What I notice is the following when I SSH to ASA's via management interface:asa1 runs 9.1(4) and when I typ...

John.Syd.Aus · 01-19-2017

I had the same problem too and figured out a solution. The problem being the control plane ACL is not blocking traffic from hosts residing on the non whitelist networks. In other words there is no permit statement covering connection from the unwante...

John.Syd.Aus · 08-06-2015

i have raised this with the TAC and it was identified as a bug Product: Cisco ASA 5500-X Series Next-Generation Firewalls Known Affected Releases:(5) 9.1(2) 9.1(4) 9.1(5) 9.1(5.10) 9.2(1) Status: Fixed Defect #: CSCuq44875 'ASA: CLI commands...

John.Syd.Aus · 08-06-2015

I understand the above loud and clear. That is different subinterfaces/IP's per VPN and having the different crypto maps binding to unique outside sub-interfaces. What about the scenario where multiple VPNs are required (each VPN terminating on a dif...

Member Since	‎08-18-2011 03:52 AM
Date Last Visited	‎03-02-2021 11:56 PM
Posts	4

User Statistics

User Activity

Issue: ASA 5500X series firewall CLI with priviledge show cmd not displaying command options

I had the same problem too

i have raised this with the

I understand the above loud