Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have Network discovery enabled but I'm seeing many MAC addresses (so far 1213) being discovered which don't correlate to any internal hosts I have. Operating system for these MAC address is also in the pending state.
If I drill down to t...
Running FireSight version 6.0.0 (build 1005)
How can I purge the data in Analysis -> Files > Captured Files -> there's no option under System -> Tools -> Data Purge
Hello,
ASA 5506-X running 9.5(1)
FirePOWER module version 6.0.0-1005
The module keeps rebooting and I'm getting the following from the console logs:
qemu: qemu_thread_create: Resource temporarily unavailable
*** EVENT: The module is being automati...
Hello,I'm in the process of setting up Primary & Secondary ACS 5.5 servers and need to assign a SSL certificate from our internal CA to each one of the nodes.Is it possible to generate a CSR with a SAN field? Regards
Hello,I've read the documentation however I'm still a little confused as to what & how the primary interface is used for. It appears that the IP associated with this interface is registered with the CM. In my instance I require the IP associated with...
Regarding your issue with blocking traffic and no logs in FireSIGHT. I've also observed this but I do see 'drop logs' on the ASA (5506) syslog but nothing logged in FireSIGHT stating the reason for the drop.
Have a look at the following:
https://bs...
I've just been hit by this bug as well... several hours later I find this thread.
I applied registry fix to Windows 2008 R2 hosting SFUA server & reboot for good measure. Updates to FMC restored.
When can we expect an update to User Agent? Reducin...
As per TAC case I raised the fix is planned to be in the following versions:
9.3.3.7, 9.4.3, and 9.5.2.3
Plan is to publish 9.5.2.3 and 9.3.3.7 at the end of March 2016.
If you are having issues then TAC can provide you with a development image whic...
I've just run into a simliar issue where all my users were unknown in FMC; my domain is set to fqdn in the Realm Configuration. User identification was working 100% but I had to re-image the SFR and when I re-set it up I made some minor changes to t...
