Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Is there any configuration document which explains about MPLS hub and spoke without any tunnel? The requirement is to avoid spoke to spoke communication directly and all traffic from spoke 1 to spoke 2 should be through the hub site, even tho...
What is the command to find out the backup path for a route in OSPF when the primary path is active. The show ip route is diplaying only the active path and the show ip ospf database is also showing the advertised-router which is active at the other ...
Hello, Is the below a valid commuity configuration?ip community-list 100 permit ASN:100Route map Com-list permit 10 (Applied In bound)match community 100Since there is no action that was specified on the match statement. If this is valid statement c...
Hello, I am confused with the route tagging between routing protocols. When i was going through different documents, i am not able to understand the tagging information. The configuration shows some tag number when redistributing between the routing...
Hello Ahmed, Thanks for the update. If we are managing the P/PE router. The PE router will have the route target export and import in spoke and hub side, but the P will have all the specific routes from hub and all the spokes. Should we have route ...
Hello Giuseppe, Thanks for the detailed reply. So if there is an inbound route map like the one below with only match and without any set statement, then will it deny all the ip comming with community value of 100? This part is bit confusing, sinc...
Hello, In the above case of inbound route map with just match community-list 100 what will be expected result of the statement? will there be any local preference or any other attributes set by the upstream provider? Also since there is no prefix ...
