Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I have a secondary ASA 5540 (both running 7.2(2)) that is not synchronizing with the NTP server. The primary is working fine. We only have one NTP server setup, which I will address, but the I'm at a loss since the primary is working fine...
Hello all,I have a VPN with a vendor, but he's using the same inside networks that I am, and he apparently can't NAT on his side so I'm trying to setup dynamic NAT for his incoming and outgoing traffic on the tunnel.This is the config I've come up wi...
Yudong - I think you've found it! 10.80.80.250 doesn't exist anymore. It's an old 30-bit network that was used for internal OSPF (setup and removed before my time).I will change the default route to the next hop address (internal core), which has a ...
Update: that IP (132.163.4.101) is a stratum 1 server (time-a.timefreq.bldrdoc.gov) with a restriction of up to 20 queries per hour from the same address. It may be possible, since both the primary and secondary ASA will have the same source address...
I can't ping the IP from either, but I can from my desktop from the inside, so likely pings are being dropped that originate from the ASA. There are no drops in the log for NTP...Here's the output from the primary. I had to set the clock manually ...
