Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hii have ASA 5510 version 8.3, i have a server in my internal network and published the HTTP service (so i configured NAT for this server).the server public IP is accessable from the internet but its not accessable from the internal network.although ...
Helloi have ASA 5520, and created an access-list (deny ip any any) and applied it to the inside interface (access-group in interface inside).but the surprise was that not all the internet traffic were blocked; like the skype and messengers!!!is there...
Helloi have two branches connected over WAN connection (MPLS) using two 2921 routers.the connection is 2M.i configured a VPN between these two sites, but after that the connection become very slow.is there any thing i can do to accelerate the connect...
i have two sites connected using two redundant WAN connections, and i am going to configure two VPN tunnels as a redundant tunnels.my question is how to configure two VPN tunnels between the two sites, so that when the first tunnel goes down the seco...
Hi Varunthank you for your reply.the exact setup is as below,- there are three zones; inside, outside, DMZ- the published server is in DMZ Zone.- the server is published using the outside interface IP address.- the users trying to access the server u...
thank you for the attached link.the problem solved; i just removed the H323 inspection from the two side firewalls and then reenabled it and every thing started to work!!!
